If you’re thinking of replacing those unflattering fluorescent lights in the bathroom or you need additional lighting than the single fixture in the living room provides, installing track lighting enhances any room. Track lighting is usually connected to the ceiling’s surface plus not recessed, making it that much easier to do it yourself. You are able to simply remove unwanted light fixtures plus use the electric box to which the old fixture was connected. And since you don’t have to do any sophisticated [electrical] wiring, you can be in a position to complete the task in less than a day.
Turn off the electric at the main breaker panel for the area you will be putting in your track lighting. When making an attempt any electric job, be certain the electricity for the circuits you’ll be functioning with is off.
Discover flexible track lighting systems here.
Cover furniture plus cupboards with a cloth to shelter them from dust or any debris which might fall while installing your new lighting. Take away the old fixtures and lights. Check the wiring to be certain the wires are still in good condition. If the insulation around the wires is hard plus crumbling, use wire strippers to strip approximately an inch of the insulation. Mark along with a pencil or with the masking tape where you want the tracks to run. Having a guide to follow can make it easier to make sure your lights go up where you need them.
The sort of screws you need depends on the sort of fabric your ceiling is formed of. If your ceiling is drywall, use anchors around the screws for added strength. If the ceiling is made from concrete, you’ll need special screws. Attach wires to the track lighting adapter. The track light can be wired the same as your old fixture. It’s easy to figure out the wire goes with the, white wire with white wire, black wire with black wire, etc. Place wire connectors over the hooked up wires screwing counterclockwise or twist the ends together depending on the sort of track lighting you have chosen. The manufacturer’s directions will tell you that you may have to do. Install lighting fixtures into the tracks. Be sure to follow the manufacturer’s directions as far as the kind of bulb to use plus how many per track. Flip the electricity back on plus test to be sure your lights are working.
Tags: